VMware Certified Professional - Network Virtualization Sample Questions:

1. Which statement best describes scaling a fault tolerant spine-leaf multipathing fabric architected for an NSX deployment?

A) Scaling should be performed by increasing the number of links from each leaf switch to the associated spine switches in the architecture.
B) Scaling should be performed by increasing the number of spine switches while maintaining point-to-point connectivity between leafs and spines.
C) Scaling should be performed by replacing 1Gbps links in the architecture with 10Gbps links.
D) Scaling should be performed by using layer 2 switching between the leaf and spine switches.

2. A vSphere administrator wants to setup an NSX Edge Service Gateway to provide traveling employees secure access to company servers located in specific network segments within the corporate Data Center. The remote access solution must provide a method to authenticate the users.
Which two methods can be used with the NSX Edge Service Gateway? (Choose two.)

A) MS-CHAP
B) Active Directory
C) TACACS+
D) RSA Secure ID

3. A network security administrator wants to monitor traffic on several VLANs configured on a
vSphere Distributed Switch. The traffic will be sent to another distributed port.
What type of port mirroring session must be configured to meet these requirements?

A) Select the session type Distributed Port Mirroring when configuring the Port Mirroring session.
B) Select the session type Remote Mirroring Destination when configuring the Port Mirroring session.
C) Select the session type Remote Mirroring Source when configuring the Port Mirroring session.
D) Select the session type Distributed Port Mirroring (legacy) when configuring the Port Mirroring session.

4. An NSX Edge Service Gateway has two interfaces:
Internal interface named Internal Access
-- IP address = 10.10.10.1
-- Network mask = 255.255.255.0
Uplink interface named Physical Uplink
-- IP address = 20.20.20.1
-- Network mask = 255.255.255.0
A vSphere administrator wants to add a SNAT rule to allow traffic from the internal network segment to access external resources via the uplink interface.
Which three steps should the vSphere administrator do to add the SNAT rule? (Choose three)

A) Choose 20.20.20.2 as the translated source IP.
B) Select 10.10.10.1 as the translated source IP.
C) Apply the SNAT rule on the Physical Uplink interface.
D) Apply the SNAT rule to the Internal Access interface.
E) Select 10.10.10.0/24 as the original subnet.

5. Which three network policy settings can only be configured on a vSphere 5.5 Distributed Switch? (Choose three.)

A) DSCP Marking
B) LACP v2
C) NetFlow
D) Network I/O Control
E) Access Control Lists (ACLs)

Solutions: