120 Q&As in UPDATED 300-815 Exam Questions Certification Test Engine to PDF
Get The Important Preparation Guide With 300-815 Dumps
NEW QUESTION # 62
A user in location X dials an extension at location Y.
The call travels through a QoS-enabled WAN network, but the user experiences choppy or clipped audio. What is the cause of this issue?
- A. codec mismatch
- B. ptime mismatch
- C. missing Call Admission Control
- D. phone class of service issue
Answer: C
NEW QUESTION # 63
Which two types of authentication are supported for the configuration of Intercluster Lookup Service?
(Choose two.)
- A. username and secret key
- B. passwords
- C. FQDN of the servers defined in DNS
- D. TokenID
- E. TLS certificates
Answer: B,E
NEW QUESTION # 64
Which IOS command creates a SIP-enabled dial peer?
- A. dial peer voice 20 sip
- B. dial-peer voice 20 pots
- C. voice dial-peer 20 sip
- D. dial-peer voice 20 voip
Answer: D
Explanation:
Reference:
https://www.ciscopress.com/articles/article.asp?p=664148&seqNum=6
NEW QUESTION # 65
Refer to the exhibit.
A call mode through the Cisco Unified Border Element to pilot 2000 is foiling. What is causing the call to foil?
- A. The destination pattern is incorrect for the dialed number.
- B. VAD was not disabled on the outgoing dial poor.
- C. No codecs are configured on the dial peers
- D. The Cisco Unified Border Element is not receiving a response to its OPTION keepahves.
Answer: A
NEW QUESTION # 66
Refer to the exhibit.
An engineer is troubleshooting a call-establishment problem between Cisco Unified Border Element and Cisco UCM. Which command set corrects the issue?
- A. SIP binding in SIP configuration mode:
voice service voip sip
bind control source-interface GigabitEthernetO/0/0 bind media source-interface GigabitEthernetO/0/0 - B. SIP binding In SIP configuration mode:
voice service volp
sip
bind control source-Interface GlgabltEthernetO/0/1 bind media source-Interface GlgabltEthernetO/0/1 - C. SIP binding in dial-peer configuration mode:
dial-peer voice 100 volp
voice-class sip bind control source-interface GigabitEthernetO/0/0
voice-class sip bind media source-interface GigabitEthernetO/0/0 - D. SIP binding In dial-peer configuration mode:
dial-peer voice 300 voip
voice-class sip bind control source-interface GigabitEthernetO/0/1 voice-class sip bind media source-interface GigabitEthernetO/0/1
Answer: C
NEW QUESTION # 67
Refer to the exhibit.
Users report that when they dial the emergency number 9911 from any internal phone, it takes a long time to connect with the emergency operator. Which action resolves this issue?
- A. Point the emergency pattern directly to the PSTN gateway.
- B. Adjust the service parameter T302 timet to the desired value.
- C. Check the Urgent Priority check box under 9.911 pattern.
- D. Adjust the service parameter T204 timer to the desired value.
Answer: C
NEW QUESTION # 68
Refer to the exhibit. An engineer is troubleshooting an issue where inbound Calls are failing after they transferred. The provider reports that update is not supported, and this is causing the calls to fail. Which command should resolve this issue?
- A. no contact-passig
- B. no midcall-signaling passthru
- C. no update-callerId
- D. rel1xx require "100rel"
Answer: D
NEW QUESTION # 69
If all patterns below are configured in Cisco Unified Communications Manager which would be used when dialing the pattern "123"?
- A. 12!
- B. 1XX (urgent Priority Set)
- C. 12[2-5]
- D. 12X (urgent priority set)
Answer: D
Explanation:
Section: Call Control and Dial Planning
NEW QUESTION # 70
Refer to the exhibit.
Users report that when they dial the emergency number 9911 from any internal phone, it takes a long time to connect with the emergency operator. Which action resolves this issue?
- A. Point the emergency pattern directly to the PSTN gateway.
- B. Adjust the service parameter T302 timet to the desired value.
- C. Check the Urgent Priority check box under 9.911 pattern.
- D. Adjust the service parameter T204 timer to the desired value.
Answer: C
NEW QUESTION # 71
Refer to the exhibit.
Which change to the translation rule is needed to strip only the leading 9 from the digit string 9123548?
- A. rule 1 /^9\(.*\)/A1/
- B. rulel /^9\(\d*\)/^1/
- C. rulel /.*\(3548S\)/^1/
- D. rule 1/^9123548/^1/
Answer: A
NEW QUESTION # 72
Refer to the exhibit.
An engineer is troubleshooting an issue where inbound calls to Cisco UCM with early media fail to establish. While investigating the issue, the engineer finds that Cisco UCM is set to require a PRACK. but the Cisco Unified Border Element is not sending it. Which command is causing this issue?
- A. voice-class sip early-media update block
- B. voice-class sip conn-reuse
- C. voice-class sip rel1xx disable
- D. voice-class midcall-signaling block
Answer: C
NEW QUESTION # 73 
Refer to the exhibit. Users report that outbound PSTN calls from phones registered to Cisco Unified Communications Manager are not completing. The local service provider in North America has a requirement to receive calls in 10-digit format. The Cisco Unified CM sends the calls to the Cisco Unified Border Element router in a globalized E.164 format. There is an outbound dial peer on Cisco Unified Border Element configured to send the calls to the provider. The dial peer has a voice translation profile applied in the correct direction but an incorrect voice translation rule applied, which is shown in the exhibit. Which rule modified DNIS in the format that the provider is expecting?
- A. rule 1 /^\([2-9]..[2-9]......$\)/ /\1/
- B. rule 1 /^/+\([^1].*\)/ /011\1/
- C. rule 1/^\+1\([2-9]..[2-9]......$\)/ /\1/
- D. rule 1 /^\+1\([2-9]..[2-9]......$\)/ /\0/
Answer: C
Explanation:
Section: Cisco Unified Border Element
Explanation/Reference:
NEW QUESTION # 74
An IP Telephony administrator is deploying IP phones The administrator has an existing Cisco UCME router with several SCCP & SIP phones registered. The administrator receives a request for a new SIP phone with MAC address 1111 2222.3333 and directory number 2050 to be added in the Cisco UCME. Which two configurations should be added in CME to support this request? (Choose two )
- A. Option D
- B. Option B
- C. Option A
- D. Option E
- E. Option C
Answer: A,E
NEW QUESTION # 75
Refer to the exhibit.
In an active SIP call between phone user A and phone user B, phone A initiates a call transfer to phone user C.
Which two scenarios are correct? (Choose two.)
- A. Phone_B sends a SIP-REFER message to the Cisco Unified CM with Phone_C information in the Refer-To section.
- B. As soon as Phone_A presses the Transfer button for the first time, Phone_B hears the MOH and the MOH audio is chosen from Phone_A User Hold MOH Audio Source settings.
- C. Phone_A sends a SIP-REFER message to the Cisco Unified Communications Manager with Phone_C information in the Refer-To section.
- D. As soon as Phone_A presses the Transfer button for the first time, Phone_B hears the MOH and the MOH audio is chosen from Phone_B User Hold MOH Audio Source settings.
- E. As soon as Phone_A presses the Transfer button for the first time, Phone_B hears the music on hold and the MOH audio is chosen from Phone_A Network Hold MOH Audio Source settings.
Answer: C,D
NEW QUESTION # 76
A user requests a feature to send an active call to the mobile phone number on the physical phone. As an administrator, what should be configured in the Cisco UCM to accomplish this?
- A. A Remote Destination Profile having the same extension as the Mobile phone's number adds the physical phone's Directory Number to the RDP as a Remote Destination. Add the softkey "Mobility" to the physical phone's softkey template.
- B. A Remote Destination Profile having the same extension as the physical phone's Directory Number, add the mobile phone number to the RDP as a Remote Destination. Add the softkey "Join" to the physical phone's softkey template.
- C. A Remote Destination Profile having the same extension as the Mobile phone's number adds the physical phone's Directory Number to the RDP as a Remote Destination. Add the softkey "Join" to the physical phone's softkey template
- D. A Remote Destination Profile having the same extension as the physical phone's Directory Number, add the mobile phone number to the RDP as a Remote Destination. Add the softkey "Mobility" to the physical phone's softkey template.
Answer: D
NEW QUESTION # 77
An administrator sees the voice register pool 1 command in a Cisco UCME configuration. Which configuration is occurring in this section?
- A. configuration for a pool of SIP phones (similar to device pool on Cisco UCM)
- B. configuration for SIP registrar service
- C. configuration items common for all SIP phones
- D. configuration for a single SIP phone
Answer: D
NEW QUESTION # 78
......
Cisco 300-815 certification exam is a critical step towards earning the Cisco Certified DevNet Specialist - Collaboration Automation and Programmability certification. It is a comprehensive exam that tests an individual's ability to implement advanced call control and mobility services on Cisco collaboration platforms. With proper preparation and a deep understanding of the exam topics, individuals can successfully pass 300-815 exam and advance their careers in the networking and collaboration field.
Prepare With Top Rated High-quality 300-815 Dumps For Success in Exam: https://www.trainingquiz.com/300-815-practice-quiz.html
Get Totally Free Updates on 300-815 Dumps PDF Questions: https://drive.google.com/open?id=1iDcuSBfgi5T7KuMdvW938REwOfbDKTgv
